Wet Process Enamels on Copper in Liquid Form

Prior to use, the enamel container should be thoroughly shaken to ensure the product is in complete suspension. If, over time, the enamel becomes too thick due to evaporation, the enamel can be thinned with mains water. The photographs show the enamels applied direct to degreased copper by spraying. If spraying is used, efficient extraction must be used to remove spray vapour from the work area. The enamels can also be applied either by dipping or with a soft brush. Each photograph shows one and two coats of enamel.

The gauge of the copper is 0.9
The actual size of each tile is 6cm x 10cm
Firing time was 3 minutes at 800 centigrade

The copper groundcoat can be used to give an off-white base on which to apply wet process colours. Higher and longer firing of wet process enamels on copper gives very interesting results as the tile colours become tinted with chemicals in the copper base.

Trade Enquiries & Purchases

These items are available to purchase at Cookson Gold .

If you are a making a trade enquiry please contact us

Wet Process Enamels on Copper in Liquid Form

Wet Process Enamel – Dark Green 10106

£3.26 – £29.77

Wet Process Enamels on Copper in Liquid Form

Wet Process Enamel – Celadon Green 10138

£3.26 – £29.77

Wet Process Enamels on Copper in Liquid Form

Wet Process Enamel – Jade 12355

£3.26 – £29.77

Wet Process Enamels on Copper in Liquid Form

Active filters

Wet Process Enamels on Copper in Liquid Form

Trade Enquiries & Purchases

These items are available to purchase at Cookson Gold .

If you are a making a trade enquiry please contact us

Login